Jeep Grand Cherokee

1993-1999 of release

Repair and car operation


Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
- Coupling and трансмиссионная a line
   The general information
   Coupling - the general description and check of serviceability of functioning
   Removal and installation of components of hydraulic system of deenergizing of coupling
   Removal, check of a condition and installation of components of coupling
   Removal, check of a condition and installation выжимного the coupling bearing
   Check of a condition and replacement of the directing bearing
   Kardannye shaft, differentials and bridges - the general information
   Condition check трансмиссионной lines
   Removal and installation карданных shaft
   Replacement карданных hinges
   Replacement of an epiploon of a shaft of a leading gear wheel of differential
   Removal, service and installation of a nave and bearings (forward wheel)
   Removal, major repairs and installation of a forward power shaft
   Removal and installation of assemblage of the forward bridge
   Removal and installation of a back semiaxis and bearing assemblage
   Removal and installation of assemblage of the back bridge
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions

e65f60b7

Removal and installation of assemblage of the forward bridge

The given procedure equally is applicable to models both 2WD, and 4WD. At work on not all-wheel drive model lower superfluous steps.

Removal

 PERFORMANCE ORDER

    Loosen the nuts of forward wheels, поддомкратьте redock of the car also establish it on props. Remove forward wheels. Отболтите supports of forward brake mechanisms also tie up them aside by means of wire pieces - watch that that brake hoses have not appeared tense (the Head Brake system). Remove brake Pads, скобы supports and brake disks (the Head Brake system). Mark position forward карданного a shaft in relation to a shaft of a leading gear wheel of differential, then disconnect карданный a shaft from the holder крестовины a shaft of a leading gear wheel (Section condition Check трансмиссионной lines). Throw out collars of the holder крестовины. Disconnect a bar of the stabilizer from arms on the bridge (the Head the Suspension bracket and a steering). Disconnect steering draughts from levers of rotary fists (the Head the Suspension bracket and a steering). Tie up them aside to elements of the bottom of the car wire pieces. Отболтите the bottom ends of shock-absorbers from the bridge. Remove steering демпфер (the Head the Suspension bracket and a steering). Remove gauge ABS (if it is provided) (see the Head the Brake system more in detail). Get under differential a hydraulic jack. At possibility of use of two jacks, one of them place under the right sleeve of the bridge for assemblage balancing (4WD). On models 2WD place a jack on the centre of assemblage of the bridge. Отболтите from the bridge the top and bottom levers of a suspension bracket (the Head the Suspension bracket and a steering). Slowly lower assemblage on the earth.

Installation

Installation make upside-down. Lifting the bridge in adjusting position, take care of correct landing of screw springs. Do not forget to replace collars of the holder крестовины. Tighten with demanded effort the fixture mentioned in Specifications.