Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
- Coupling and трансмиссионная a line
   The general information
   Coupling - the general description and check of serviceability of functioning
   Removal and installation of components of hydraulic system of deenergizing of coupling
   Removal, check of a condition and installation of components of coupling
   Removal, check of a condition and installation выжимного the coupling bearing
   Check of a condition and replacement of the directing bearing
   Kardannye shaft, differentials and bridges - the general information
   Condition check трансмиссионной lines
   Removal and installation карданных shaft
   Replacement карданных hinges
   Replacement of an epiploon of a shaft of a leading gear wheel of differential
   Removal, service and installation of a nave and bearings (forward wheel)
   Removal, major repairs and installation of a forward power shaft
   Removal and installation of assemblage of the forward bridge
   Removal and installation of a back semiaxis and bearing assemblage
   Removal and installation of assemblage of the back bridge
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions


e65f60b7

Removal, service and installation of a nave and bearings (forward wheel)

Removal

Assemblage of a nave with the bearing and accompanying components


The given procedure is applicable only to models 4WD. On not all-wheel drive models bearings of tight type are used.


 PERFORMANCE ORDER

    Remove a nave cap, шплинт and a nut clamp, then give a nave nut.
    Before поддомкрачивать the car remove шплинт and a counternut, then ослабьте a nave nut.
    Loosen the nuts of fastening of a forward wheel, поддомкратьте redock of the car also establish it on props. Remove a wheel. Remove a support and a disk of the brake mechanism (the Head Brake system). Remove a nave nut. Отболтите assemblage of a nave from a rotary fist also beat out it from a nest in a fist. If шлицы naves "have become attached" to an axis, take advantage of a stripper.
    Give a forward bolt (arrow) …

… and two back bolts (arrow) of fastening of assemblage of a nave to a rotary fist (12 beam head is required).

    Cautiously bring down assemblage of a nave from a rotary fist.

Service

The block of a nave with the bearing is not subject to dismantling. In case of damage or deterioration of a nave or the bearing all assemblage is subject to replacement.

Installation

 PERFORMANCE ORDER

    Emery paper smooth out an aperture in a rotary fist, having removed from it all traces of corrosion and a dirt. Grease шлицы drive and greasing for wheel bearings. Of the same greasing take advantage for greasing of walls of an aperture in a rotary fist and establish nave assemblage into place. Tighten bolts of fastening of a nave to a fist with demanded effort. Establish into place a washer and a nave nut, strongly tighten a nut. Establish a disk and a support of the brake mechanism (the Head Brake system), put on a wheel and lower the car on the earth. Tighten nuts of fastening of a wheel with demanded effort (the Head of Adjustment and routine maintenance). Tighten a nut of a nave with demanded effort, establish a clamp and new шплинт. Put on a nave cap.