Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
- Coupling and трансмиссионная a line
   The general information
   Coupling - the general description and check of serviceability of functioning
   Removal and installation of components of hydraulic system of deenergizing of coupling
   Removal, check of a condition and installation of components of coupling
   Removal, check of a condition and installation выжимного the coupling bearing
   Check of a condition and replacement of the directing bearing
   Kardannye shaft, differentials and bridges - the general information
   Condition check трансмиссионной lines
   Removal and installation карданных shaft
   Replacement карданных hinges
   Replacement of an epiploon of a shaft of a leading gear wheel of differential
   Removal, service and installation of a nave and bearings (forward wheel)
   Removal, major repairs and installation of a forward power shaft
   Removal and installation of assemblage of the forward bridge
   Removal and installation of a back semiaxis and bearing assemblage
   Removal and installation of assemblage of the back bridge
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions


e65f60b7

Removal and installation of components of hydraulic system of deenergizing of coupling

Components of assemblages of the main and executive cylinders of coupling


The hydraulic system of deenergizing of coupling is served as uniform assemblage. If in system there are leaks or in it air gets, to replace it also follows the uniform block.


 PERFORMANCE ORDER

    Поддомкратьте the car also establish it on props. Give nuts of fastening of the executive cylinder to the coupling case. Liberate a hydraulic line of coupling from fixing clips on the case. Lower the car on the earth. Remove a ring of the holder, the flat and goffered washers, fastening a pusher of the main cylinder to a coupling pedal.

Details of knot of joining of a pusher with a coupling pedal.

    Disunite an electric socket of wires of the gauge-switch of position of a pedal of coupling, then remove a rod of a pusher of the main cylinder from a finger of its fastening to a pedal. Check up a condition of plugs of a finger. Replace the worn out components. In order to avoid a liquid spillage make sure that the cover of the tank of the main cylinder is densely closed, then give screws of fastening of the tank and a nut of hairpins of fastening of the cylinder to a partition of an impellent compartment. Remove all assemblage. Do not try to disconnect a hydraulic line from the main or executive cylinders. Installation make upside-down. All fixture tighten with demanded effort.