Disconnect a negative wire from the battery.
Remove the block of a heater/conditioner of air, having taken out it from under the panel of devices (Has undressed Removal and installation of the heat exchanger of a heater).
Turn the removed block upside down and give screws of fastening of its two half to each other.
Remove the central heating sleeve and give the screw.
|
|
For providing of access to last screw (marksman) remove the central heating sleeve.
|
Cautiously turn the block of a heater/conditioner of air and separate the top half of its casing from the bottom.
Take the evaporator from the bottom half of casing.
Installation make upside-down. If the evaporator is replaced new, add in system of 2 ounces (56,7) fresh refrigerator oils (type R-134a).
|
|
In the butt connections of lines of system equipped with spring locks at assemblage the sealing rings suitable for the use in contact to oil of type R-134a should be established. |
In the same workshop where made a discharge, empty, charge and check up system on leaks.
|
|
