On the models equipped with the conditioner of air, make a system discharge (the prevention above see).
Disconnect a negative wire from the battery.
Empty cooling system (the Head of Adjustment and routine maintenance) and disconnect hoses from inlet and final unions of the heat exchanger of a heater.
Remove the console lower a steering column and remove assemblage of the panel of devices (the Head the Body).
Disunite an electric socket of the motor of the fan of a heater (Has undressed Removal and installation of the block of the fan of a heater).
On the models equipped with the conditioner of air, disconnect lines of system from the evaporator on a partition of an impellent compartment. For a detachment of unions special clips are required.
|
|
For a stretching of a ring spring at a detachment of lines of a central air it is necessary to take advantage of the special tool.
|
Remove a broad tank (Has undressed Removal and installation of a radiator and a broad tank of system of cooling).
Remove from a partition of an impellent compartment the processor (РСМ), without disuniting 60-klemmnyj an electric socket.
Delay РСМ far enough to give fixing nuts of the block of a heater/conditioner of air (three behind the processor, one - over the distributor on models with engine V8) from hairpins on the party turned towards the engine to a partition of an impellent compartment.
|
|
Give nuts of fastening of a casing on the impellent party to a compartment partition.
|
Mark and disunite electric sockets of the block of a heater/conditioner of air and resistive assemblage of the motor of the fan. Disconnect a vacuum hose from the vacuum motor.
Remove a drain tube of the evaporator.
Remove a sleeve blowing glasses (over the block of a heater/conditioner of air).
|
|
Disconnect a sleeve of heating of back foot wells.
|
Give nuts from hairpins from the party of a partition of an impellent compartment turned to salon and take assemblage of a heater/conditioner of air from the car.
Give fixing screws and remove the heater heat exchanger, having pulled it vertically upwards from a casing.
|
|
The heater heat exchanger is taken from a casing of the block of a heater/conditioner of air.
|
|
|
