Jeep Grand Cherokee

1993-1999 of release

Repair and car operation


Jeep Grand Cherokee
- Cars of mark Jeep Grand Cherokee
   + Identification numbers of the car
   Acquisition of spare parts
   + Technics of service, the tool and the workplace equipment
   + Поддомкрачивание and towage
   Start of the engine from the auxiliary power supply
   + Automobile химикалии, oils and greasings
   - Diagnostics of malfunctions
      The engine
      Engine electric equipment
      The power supply system
      Cooling system
      Coupling
      Manual box of a gear change (РКПП)
      Automatic transmission (АТ)
      Distributing box
      Kardannyj shaft
      Bridges
      Brake system
      Suspension bracket and steering
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions

e65f60b7

Coupling

Coupling is not switched off (control lever РКПП is not translated freely in position of a reverse gear and back at the pedal of coupling squeezed out to a floor)

    Leaks in hydraulic system of coupling take place. Check up a condition of the main and executive cylinders and all hydraulic lines (the Head Coupling and трансмиссионная a line). Will drive or is damaged a coupling disk (the Head Coupling and трансмиссионная a line).

Coupling revolves (engine turns raise without increase in speed of movement of the car)

    The coupling disk is polluted by oil or its frictional overlays are wiped. Remove coupling (the Head Coupling and трансмиссионная a line) and check up a condition of its components. The coupling disk was not earned extra properly. For definitive extra earnings of a new disk it can be demanded from 30 to 40 normal starts of the car. The coupling disk/basket (the Head Coupling and трансмиссионная a line) is worn out press.

At coupling inclusion there is a strong vibration

    The coupling disk is made oily. Remove coupling (the Head Coupling and трансмиссионная a line) and check up a condition of its components. Eliminate all revealed leaks. Support of the engine or a check point or ослабло their fastening are worn out. These blocks can move slightly at coupling deenergizing. Check up a condition of support and bolts of their fastening (Head Rjadnyj the six-cylinder engine). Are worn out шлицы naves of a conducted disk (a coupling disk). Remove coupling (the Head Coupling and трансмиссионная a line) and check up a condition of its components. The disk/basket of coupling or flywheel will drive press. Remove coupling (the Head Coupling and трансмиссионная a line) and check up a condition of its components and a flywheel.

Squeal or roar arise at full inclusion of coupling (the pedal is released)

It is jammed выжимной the coupling bearing in the holder of the bearing on a check point. Remove coupling (the Head Coupling and трансмиссионная a line) and check up a bearing condition. Remove all agnails and teases, and grease the bearing before installation into place.

Squeal or roar arise at full deenergizing of coupling (the pedal is squeezed out)

    It is worn out or damaged выжимной the bearing (the Head Coupling and трансмиссионная a line). Springs (or diaphragm petals) a press disk in a coupling basket (the Head Coupling and трансмиссионная a line) are worn out or damaged.

The coupling pedal remains squeezed out to a floor after it отпускания

    Draught or выжимной the bearing is jammed. Check up a draught condition, if necessary remove coupling components. Make sure that the pedal emphasis is established correct type.