Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grand Cherokee
- Cars of mark Jeep Grand Cherokee
   + Identification numbers of the car
   Acquisition of spare parts
   + Technics of service, the tool and the workplace equipment
   + Поддомкрачивание and towage
   Start of the engine from the auxiliary power supply
   + Automobile химикалии, oils and greasings
   + Diagnostics of malfunctions
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions

yeseter e65f60b7


Start of the engine from the auxiliary power supply

At start of the engine from the auxiliary battery it is necessary to remember necessity of performance of following requirements:

  • Before connection of the auxiliary battery make sure that ignition is switched off (a key will turn in position OFF).
  • Make sure that all electric equipment of the car (lighting devices, a heater, screen wipers, etc.) is switched off.
  • Necessarily put on goggles.
  • Make sure that the auxiliary battery on target pressure corresponds established on your car.
  • If start is made from the battery established on other car, track, that between cars there were no things in common!
  • Make sure, transmission is established on neutral transfer (РКПП), or in position “Р” (Parking) (АТ).
  • If the auxiliary battery concerns type subject to service, remove from it ventilating covers and cover apertures with rags.

Connect a red wire from the complete set for start of the engine from an auxiliary source between positive (+) plugs of both batteries. Then connect the second (black) wire from the complete set at first to negative (-) the plug of the auxiliary battery, and then to well earthed point on your car (such as a bolt or an arm on the engine block, whenever possible within distance in 45 sm from the battery). Make sure that wires do not touch moving components of an impellent compartment (such as fan blades, приводные belts, etc.).

Connect wires from the complete set for start of the car from the auxiliary power supply as it should be shown on drawing (pay attention that the negative wire of the auxiliary battery is not connected to the negative plug of the sat down battery).

Start the engine from the auxiliary battery, then, having left its working on single turns, include the motor of the fan of a heater (for the maximum speed) or a heater of glass for smoothing of peaks of pressure which can arise at a detachment of wires (do not include lighting devices since considerable jumps of pressure can lead перегоранию lamps). Disconnect wires, operating as it should be the return to an order of their connection.