Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grand Cherokee
- Cars of mark Jeep Grand Cherokee
   + Identification numbers of the car
   Acquisition of spare parts
   + Technics of service, the tool and the workplace equipment
   + Поддомкрачивание and towage
   Start of the engine from the auxiliary power supply
   + Automobile химикалии, oils and greasings
   - Diagnostics of malfunctions
      The engine
      Engine electric equipment
      The power supply system
      Cooling system
      Coupling
      Manual box of a gear change (РКПП)
      Automatic transmission (АТ)
      Distributing box
      Kardannyj shaft
      Bridges
      Brake system
      Suspension bracket and steering
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions

e65f60b7 Купить золотой браслет женский недорого в москве смотрите на http://www.meille.ru.


Manual box of a gear change (РКПП)

Everywhere, where it is not specified especially, references to materials of the Head Automatic transmission are meant.

At established on neutral transfer of a check point to an engine operating time extraneous noise take place

  1. The bearing of a primary shaft is worn out.
  2. The bearing of a leading gear wheel of a conducted shaft is damaged.
  3. Bearings of an intermediate shaft are worn out.
  4. Washers of adjustment axial люфта an intermediate shaft are worn out or damaged.

Extraneous noise take place in any position РКПП

  1. Any of the reasons set forth above and-or:
  2. In a check point the insufficient quantity трансмиссионного oils (its level has fallen) is filled in (the checks listed in the Head of Options and routine maintenance) see.

Extraneous noise arise on any concrete transfer

  1. Teeth of a gear wheel of the given transfer is worn out, damaged or chopped off.
  2. The synchronizer of the given transfer is worn out or damaged.

Occurs «соскакивание» a check point from the higher transfer

  1.  Ослабло box fastening on картере couplings.
  2. Between a boat of a box and the engine the dirt or a box has got was displaced in relation to the engine.

At a gear change there are complications

  1. It is not completely squeezed out coupling (the description of adjustment of coupling in the Head of Adjustment and routine maintenance see) (is switched off).
  2. Draught of switching is damaged, ослабло its fastening or adjustment is broken. Make careful check of a condition of components, in case of need replace the defective.

Leaks трансмиссионного oils take place

  1. In a check point the excessive quantity трансмиссионного oils (the description of procedure of check of level of oil see in the Head of Adjustment and routine maintenance) is filled. In case of need merge surplus.
  2. The epiploon of a box or epiploon приводной speedometer gear wheels requires replacement.