Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
- Brake system
The general information
System of antiblocking of brakes (ABS) - the general information
Replacement колодок disk brake mechanisms
Removal, major repairs and installation of a support of the disk brake mechanism
Condition check, removal and installation of a brake disk
Replacement of boots of drum-type brake mechanisms
Removal, major repairs and installation of wheel cylinders
Removal and installation of the combined valve (regulator)
Removal and installation of the main brake cylinder
Check of a condition and replacement of brake hoses and lines
Prorolling of brake system
Functioning check, removal and installation of the vacuum amplifier of brakes
Functioning check, removal, installation and adjustment of the gauge-switch of stoplights
Adjustment of a lay brake
Replacement of cables of a drive of a lay brake
Replacement of boots of a lay brake (disk brake mechanisms of back wheels)
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions
|
Brake system
Specifications
The general parametres
Disk brake mechanisms
The minimum admissible thickness of a brake disk |
It is beaten out or cast on a disk body
|
As much as possible admissible fluctuations of a thickness of a disk (mm)
|
Disk of the forward brake mechanism
|
No more than 0,013 mm
|
Disk of the back brake mechanism
|
No more than 0,025 mm
|
As much as possible admissible palpation of a disk (mm) |
0,13
|
The minimum admissible thickness brake колодок |
|
Drum-type brake mechanisms
As much as possible admissible diameter of a drum |
It is beaten out or cast on a drum body
|
The minimum admissible thickness of frictional overlays of brake boots |
|
Efforts of a tightening of carving connections, Н•м
Nuts of fastening of the vacuum amplifier of brakes |
41
|
Nuts of fastening of the main brake cylinder
|
13,0 — 24,9
|
Fixing pins of supports of brake mechanisms (forward and back)
|
9,5 — 20,3
|
Hollow bolt of fastening of a brake hose to a support of the brake mechanism (forward and back brake mechanisms)
|
31
|
Bolts of fastening of wheel cylinders |
10,2
|
|
|