Jeep Grand Cherokee

1993-1999 of release

Repair and car operation


Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
- System of an electric equipment of the engine
   The general information
   Start of the engine from an auxiliary source
   Check of a condition and replacement of wires of the battery
   Removal and battery installation
   Ignition system - the general information
   Check of serviceability of functioning of system of ignition
   Check of serviceability and replacement of the coil of ignition
   Check of serviceability and replacement of the gauge of position of a camshaft
   Removal and distributor installation
   Charge system - the general information and safety measures
   Check of serviceability of functioning of system of a charge
   Removal and generator installation
   Start system
   Diagnostics of malfunctions of a starter without its removal from the car
   Removal and starter installation
   Removal and installation of the traction relay (engines in volume 4.0)
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions

e65f60b7

Removal and generator installation

 PERFORMANCE ORDER

    Disconnect a negative wire from the battery.

If the radio tape recorder in your car is equipped by a security code before to disconnect from the battery a negative wire make sure that the given code know.

    Mark and disunite electric sockets and the grounding tyre on the generator.
Electric sockets of the generator.
    Turn a pulley натяжителя and remove приводной a belt.
    Turn a pulley натяжителя clockwise, having removed a tension drive a belt of tape type (the engine 5.2 is shown).
    Give adjusting and axial bolts and remove the generator from the engine.

Removal of bolts of the top arm of the generator (the engine 5.2 is shown).

    The second key keep a bolt from проворачивания at отдавании nuts.
    At generator replacement take with itself in shop old. Track, that the got new/restored block was identical to the removed. Examine plugs - they should coincide by quantity, the size and a site. In summary compare identification numbers - they should be beaten out on the case of the generator or are printed on the label attached to the case. Numbers of both blocks should coincide. More often new blocks are delivered without pulleys, therefore rearrange a pulley from the removed generator on new/restored. Installation make upside-down. After generator installation make tension adjustment drive a belt (the Head of Adjustment and routine maintenance). For check of serviceability of functioning of the new generator measure it зарядное pressure (Section Check of serviceability of functioning of system of a charge).