|
|
Jeep Grand Cherokee1993-1999 of releaseRepair and car operation |
|
|
Jeep Grand Cherokee - Cars of mark Jeep Grand Cherokee + Identification numbers of the car Acquisition of spare parts - Technics of service, the tool and the workplace equipment Technics of service Fixture The sizes of fixture Procedure and order of a tightening of carving connections Dismantling of components Prokladochnye surfaces Councils about removal of hoses The tool The workplace equipment + Поддомкрачивание and towage Start of the engine from the auxiliary power supply + Automobile химикалии, oils and greasings + Diagnostics of malfunctions + Options and routine maintenance + Рядный the six-cylinder engine + Engine V8 + Procedure of the general and engine major repairs + Systems of cooling, heating and air conditioning + The power supply system and release of the fulfilled gases + System of an electric equipment of the engine + Systems of decrease in toxicity of the fulfilled gases and engine management + Manual box of a gear change + Automatic transmission + Distributing box + Coupling and трансмиссионная a line + Brake system + Suspension bracket and steering + Body + System of an onboard electric equipment + Controls and operation receptions 
|
The workplace equipment Speaking about the tool, it is necessary to recollect the workplace equipment. If carrying out of more serious work, than simple maintenance service is necessary, it is necessary to take care of preparation of the suitable worker of a platform. It is necessary to recognise that many motorists are compelled to make removal of the engine and other similar works far not in the conditions of garage or a workshop. However, in any case the important requirement is roof or awning presence. Whenever possible, any procedures on dismantling of parts of systems of the car should be made on a pure flat workbench, or a strong table of convenient height. The workbench should be necessarily equipped by a vice. Presence of a vice with disclosing of sponges to 100 mm and with soft overlays on sponges is sufficient. As already it was mentioned above, on a working platform the pure dry place for storage of the tool, lubricant and cleaning liquids, шпаклевок, paint and varnish materials, etc. should be equipped It is necessary to notice that absolutely necessary tool is the electrodrill, hence, the working platform should be equipped by the power supply for its connection. Presence of a drill with a cartridge to 9.5 mm and a set of qualitative drills appreciably will facilitate carrying out of many procedures. At last, on a workplace always there should be a sufficient stock of old newspapers and pure, not ворсящейся the rags, intended for cleaning of a working platform, the tool and car details. It is necessary to hand over working off in the centres on recycling in tight container. Never make any works on the barefaced painted surface of the car, use protective overlays on wings, or, at the worst, cover the polished surfaces with old blankets. |
|