Jeep Grand Cherokee

1993-1999 of release

Repair and car operation


Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
- System of an electric equipment of the engine
   The general information
   Start of the engine from an auxiliary source
   Check of a condition and replacement of wires of the battery
   Removal and battery installation
   Ignition system - the general information
   Check of serviceability of functioning of system of ignition
   Check of serviceability and replacement of the coil of ignition
   Check of serviceability and replacement of the gauge of position of a camshaft
   Removal and distributor installation
   Charge system - the general information and safety measures
   Check of serviceability of functioning of system of a charge
   Removal and generator installation
   Start system
   Diagnostics of malfunctions of a starter without its removal from the car
   Removal and starter installation
   Removal and installation of the traction relay (engines in volume 4.0)
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions

e65f60b7

Removal and battery installation

If the car is translated in a non-use mode (the engine will not be started) for the term of more than 20 days, it is necessary to remove safety lock IOD in centre value of distribution of power supplies in order to avoid an excessive discharge of the battery.


 PERFORMANCE ORDER

    Disconnect from the battery both wires.

First of all always disconnect from the battery a negative wire in order to avoid casual short circuit at отдавании клеммного a clip positive.


If the radio tape recorder in your car is equipped by a security code before to disconnect from the battery a negative wire make sure that the given code know.

    Remove a clamping lath of the battery.
    Give two nuts (arrow), then remove from the battery a clamping lath.
    Remove from the battery a thermofilter.
    Remove the battery. Be cautious - it weighs much enough.

In shops of automobile accessories for the reasonable price it is possible to get the special bandages equipped with handles for simplification of procedure of extraction of the battery from the car.

    Having removed the battery, check up a condition of its holder (pallet) (on presence of traces of corrosion and other damages). If corrosion has passed to a battery arm, give bolts and remove an arm. Cleaning of a support with application of a solution of baking soda will help to protect an arm from the further oxidation.
    Components of the pallet and clamping lath of the battery.
    If it is necessary to replace the battery, track that again got battery on a design, a standard size and target characteristics corresponded to the replaced. Installation make upside-down.