Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
- System of an electric equipment of the engine
   The general information
   Start of the engine from an auxiliary source
   Check of a condition and replacement of wires of the battery
   Removal and battery installation
   Ignition system - the general information
   Check of serviceability of functioning of system of ignition
   Check of serviceability and replacement of the coil of ignition
   Check of serviceability and replacement of the gauge of position of a camshaft
   Removal and distributor installation
   Charge system - the general information and safety measures
   Check of serviceability of functioning of system of a charge
   Removal and generator installation
   Start system
   Diagnostics of malfunctions of a starter without its removal from the car
   Removal and starter installation
   Removal and installation of the traction relay (engines in volume 4.0)
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions


e65f60b7

Removal and installation of the traction relay (engines in volume 4.0)

 PERFORMANCE ORDER

    Disconnect a negative wire from the battery.

If the radio tape recorder in your car is equipped by a security code before to disconnect from the battery a negative wire make sure that the given code know.

    Remove a starter (Has undressed Removal and starter installation). Disconnect the tyre going from the traction relay to the plug of a starter.
    For branch of the traction relay from a starter remove a starter and disconnect the tyre from стартерной plugs of the relay (marksman).
    Give screws of fastening of the traction relay to a starter and remove the relay.
    For a detachment of the traction relay from a starter give fixing screws (arrows) in its forward part (firm Mitsubishi starter is shown).
    Having removed the traction relay check up a condition of a teeth of a gear wheel of a starter. If a teeth is damaged, it is necessary to examine also a gear wreath of a flywheel/privodnogo of a disk. Installation make upside-down.