Jeep Grand Cherokee

1993-1999 of release

Repair and car operation


Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
- Рядный the six-cylinder engine
   The general information
   The repair procedures, which performance it is possible without extraction of the engine from the car
   Reduction in position ВМТ of a step of compression of the piston of the first cylinder
   Removal and installation of a cover of a head of cylinders
   Removal, check of a condition and installation коромысел and bars of pushers
   Replacement клапанных springs, their plates and маслоотражательных caps
   Removal and installation of the inlet pipeline / a final collector
   Removal and installation of a head of cylinders
   Replacement of a forward epiploon of a cranked shaft
   Condition check, removal and installation of a cover of a distributive chain, chain and its asterisks
   Removal, check of a condition and installation of a camshaft, bearings and hydraulic pushers
   Removal and pallet installation картера
   Removal, check of a condition and installation of the oil pump
   Removal and installation of a flywheel/privodnogo of a disk
   Replacement of a back epiploon коленвала
   Check of a condition and replacement of rubber pillows of support of the engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions

e65f60b7

Removal and installation of a cover of a head of cylinders

 PERFORMANCE ORDER

    Remove from a cover of a head of cylinders hose CCV both a hose and a ventilation tube картера.

Site of hoses CCV and ventilation картера (arrow).

    Remove clips of a plait of wires, remembering position of their hairpins for correct installation at assemblage. Liberate from clips on the top part of a cover of a head of cylinders cables of gas, a drive throttle заслонки in a mode kik-daun and control systems of speed (темпостатом). Disconnect cables from the case of a throttle and will put them aside.
    Disconnect from the case of a throttle cables of gas, a drive throttle заслонки in a mode kik-daun and темпостата, liberate cables from clips on a cover of a head of cylinders and will put them aside.
    Give fixing bolts and uncover heads of cylinders. If the cover "has become attached", is accurate обстучите it on perimetre a hammer with soft the brisk. Do not try to hook at all a cover the lever got under the interfaced surface of a flange! Smooth out interfaced surfaces, carefully having removed with all of them oil traces, having wiped the rags moistened in acetone.

Such covers are equipped with the reusable linings formed of fallen asleep hermetic RTV and fastening directly to a cover.

    Presence in such lining of small cracks is admissible and is eliminated by greasing of the damaged site by hermetic RTV before cover installation into place. Establish a cover and screw bolts. Tighten bolts with demanded effort. Establish ventilating hoses and the servo-driver темпостата (if it is provided). Start the engine and check up it on leaks.