Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
- Рядный the six-cylinder engine
   The general information
   The repair procedures, which performance it is possible without extraction of the engine from the car
   Reduction in position ВМТ of a step of compression of the piston of the first cylinder
   Removal and installation of a cover of a head of cylinders
   Removal, check of a condition and installation коромысел and bars of pushers
   Replacement клапанных springs, their plates and маслоотражательных caps
   Removal and installation of the inlet pipeline / a final collector
   Removal and installation of a head of cylinders
   Replacement of a forward epiploon of a cranked shaft
   Condition check, removal and installation of a cover of a distributive chain, chain and its asterisks
   Removal, check of a condition and installation of a camshaft, bearings and hydraulic pushers
   Removal and pallet installation картера
   Removal, check of a condition and installation of the oil pump
   Removal and installation of a flywheel/privodnogo of a disk
   Replacement of a back epiploon коленвала
   Check of a condition and replacement of rubber pillows of support of the engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions




The general information

The given Chapter is devoted the description of procedures of repair рядного the 6-cylinder engine in volume of 4.0 l which performance is possible without extraction of last of the car. All information, concerning procedures of removal and engine installation, and also major repairs of the block and a head of cylinders can be found in the Head of Procedure of the general and engine major repairs.

The description offered below repair procedures is made on the basis of the assumption that the engine remains established on the car. If the engine is removed and transferred on the assembly stand, many from recommended below steps will appear inapplicable.

The specifications resulted in the beginning of the given Chapter concern only the procedures described here. Spetsifikatsionnye requirements to performance of procedures of repair and restoration of the block and a head of cylinders are stated in the beginning to the Head of Procedure of the general and engine major repairs.