Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
- Body
   The general information
   Care of a body
   Care of the panels of furnish made of vinyl
   Care of an upholstery and salon rugs
   Repair of insignificant damages кузовных panels
   Repair of considerable damages of a body
   Service of loops and locks
   Replacement wind and motionless glasses
   Removal, installation and adjustment of position of a cowl
   Removal and installation of the lock of a cowl and cable of its drive
   Removal and installation to the place of the panel of a decorative lattice of a radiator
   Removal and installation of a forward wing
   Removal and installation of bumpers
   Removal and installation of the panel of an internal upholstery of a door
   Removal, installation and adjustment of position of a door
   Removal and installation of handles, the cylinder and clamp (latch) of the lock of a door
   Removal and installation of a windowpane of a door
   Removal and installation of a regulator of a window of a door
   Removal and installation of the central console
   Removal and installation of the panel of an upholstery of a door of a back
   Removal, installation and adjustment of position of a door of a back
   Replacement of an emphasis of a door of a back
   Removal and installation of facing of a combination of devices
   Removal and installation of facings of a control panel
   Removal and control panel installation
   Removal and installation of covers of a casing of a steering column
   Removal and installation of rear-view mirrors
   Remove also lattice installation обтекателя
   Removal and installation of seats
   Control кузовные the sizes
+ System of an onboard electric equipment
+ Controls and operation receptions




Removal, installation and adjustment of position of a door of a back

 PERFORMANCE ORDER

  1. Open a door of a back and cover the painted surface of a body over a doorway an old blanket or a special cover.
  2. Remove the panel of an internal upholstery, disunite electric sockets and take plaits of wires from a door.
  3. Lead round a marker flanges of loops of a door of a back.
  4. Having asked the assistant to adhere a door, remove a telescopic emphasis (Section Replacement of an emphasis of a door of a back).
  5. Give bolts of loops and remove a door of a back from the car.
  1. For отдавания bolts of loops of a door of a back (arrow) the key of type TORX is required.
  1. Installation make upside-down. At installation to the place of plaits of wires be careful not to cut isolation about keen edges of apertures.
  2. On termination of installation close a door of a back and make sure of adequacy of its arrangement in a body aperture.
  3. If the door requires position updating, ослабьте slightly bolts of loops, cautiously close a door and отцентруйте it in an aperture (the drummer of the lock should appear on the door centre). Very cautiously open a door and tighten bolts.