Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
- Suspension bracket and steering
   The general information
   Removal and installation of the forward stabilizer of cross-section stability and its plugs
   Removal and installation of forward shock-absorbers
   Removal and installation of a cross-section jet bar of a forward suspension bracket
   Removal and installation of levers of a forward suspension bracket
   Removal and installation of screw springs of a forward suspension bracket
   Removal and installation of rotary fists
   Replacement of spherical hinges
   Removal and installation of a bar of the back stabilizer of cross-section stability
   Removal and installation of back shock-absorbers
   Removal and installation of a cross-section jet bar of a back suspension bracket
   Removal and installation of levers of a back suspension bracket
   Removal and installation of screw springs of a back suspension bracket
   Removal and steering wheel installation
   Condition check, removal and installation of a steering drive
   Removal and installation of the steering mechanism
   Removal and installation of the pump of system of hydrostrengthening of a wheel
   Prorolling of system of hydrostrengthening of a wheel
   Wheels and tyres - the general information
   Corners of installation of forward wheels - the general information
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions


e65f60b7

Prorolling of system of hydrostrengthening of a wheel

On termination of any procedure demanding a detachment of hydraulic lines system of hydrostrengthening of a wheel should be pumped over for the purpose of removal from it air and reception of adequate strengthening at steering wheel turn.

 PERFORMANCE ORDER

    Having established forward wheels in rectilinear position, check up level of a liquid of system, in case of need make having added, having finished it to a mark "With" (Cold) on measuring probeе. Start the engine and leave working on turns of fast idling. Repeat check of level of a liquid in system. In case of need add it to a label "With" on probeе. Pump over system, turning operated wheels from an emphasis against the stop, but without blows on course terminators. Air which has thus got to system will be expelled from it. In the course of procedure performance watch, that its tank constantly was full. After air will be removed from system again establish wheels in rectilinear position and, before to switch off the engine, allow to it to work some more minutes. Spend trial runs, checking serviceability and noiselessness of functioning of a steering. Repeat check of level of a liquid at разогретом to normal working temperature the engine - it should be in mark area Н (Hot) on probeе. In case of need make having added (the Head of Adjustment and routine maintenance).