Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
- Suspension bracket and steering
   The general information
   Removal and installation of the forward stabilizer of cross-section stability and its plugs
   Removal and installation of forward shock-absorbers
   Removal and installation of a cross-section jet bar of a forward suspension bracket
   Removal and installation of levers of a forward suspension bracket
   Removal and installation of screw springs of a forward suspension bracket
   Removal and installation of rotary fists
   Replacement of spherical hinges
   Removal and installation of a bar of the back stabilizer of cross-section stability
   Removal and installation of back shock-absorbers
   Removal and installation of a cross-section jet bar of a back suspension bracket
   Removal and installation of levers of a back suspension bracket
   Removal and installation of screw springs of a back suspension bracket
   Removal and steering wheel installation
   Condition check, removal and installation of a steering drive
   Removal and installation of the steering mechanism
   Removal and installation of the pump of system of hydrostrengthening of a wheel
   Prorolling of system of hydrostrengthening of a wheel
   Wheels and tyres - the general information
   Corners of installation of forward wheels - the general information
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions


e65f60b7

Removal and installation of levers of a back suspension bracket

In avoidance соскальзывания картера the bridge from the position that considerably would complicate the subsequent assemblage, remove and establish each of suspension bracket levers serially. If for any reason it is necessary to remove more than one lever, prop up the bridge тележечным a jack.

Поддомкратьте a back of the car also establish it on props.

The top lever

 PERFORMANCE ORDER

    Give a nut and a bolt of fastening of the top lever to an arm картера the bridge.

Details of installation of the lever of a back suspension bracket.

    For a detachment of the top lever of a back suspension bracket from an arm картера the bridge give this nut (marksman) and a bolt (in a picture it is not visible).
    Give a nut with a bolt, fastening the top lever of a suspension bracket to an arm of a beam of a frame and remove the lever from the car.
    For a detachment of the top lever of a suspension bracket from an arm of a beam of a frame give a nut (having reached it through an aperture in an opposite wall of a beam and a bolt (arrow).
    Check up the lever on presence of cracks and deformations. Plugs examine on presence of cuts and cracks. In case of revealing of defects replace the lever. Installation make upside-down. All fixture tighten with demanded effort.

The bottom lever

 PERFORMANCE ORDER

    Give a nut and a bolt of fastening of the bottom lever to a bridge arm.
    For a detachment of the bottom lever of a back suspension bracket from an arm картера the bridge give these a bolt with (arrow) nut.
    Give a bolt with a nut of fastening of the bottom lever to a beam of a frame and remove the bottom lever from the car.
    For a detachment of the bottom lever of a back suspension bracket from an arm of a beam of a frame give a nut (in a picture it is not visible) and this bolt (arrow).
    Installation make upside-down. All fixture tighten with demanded effort.

Both levers

Remove jacks and lower the car on the earth.