Removal and installation of the main brake cylinder
The given work also should not be made by forces of the mechanic-fan. It is besides connected not with complexity of procedures of removal-installation, and caused by necessity of carrying out of adequate prorolling HCU. Manufacturers recommend to make preliminary prorolling of the main cylinder on a workbench before installation on the car.
After installation will be made, the main brake cylinder and HCU ABS should be pumped over with application of scanner DRB II (then all system should be pumped over also in manual). The scanner is rather expensive device and can serve as a favourable investment only for a workshop of dealer branch. If on your car there are any problems connected with refusals of the combined regulator, tow off it in a workshop of dealer branch or on a specialised car repair shop.
|
