Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
- Automatic transmission
The general information
Diagnostics of malfunctions - the general information
Removal and installation of the lever of switching
Check of a condition and adjustment of a cable of switching
The description, replacement and adjustment of a cable of a drive throttle заслонки in a mode kik-daun (TV-cable)
Serviceability check, adjustment and replacement of the gauge-switch of the permission of start
Adjustment of a cable lay блокиратора
Check of a condition and replacement of a support of transmission
Epiploon replacement
The design description, removal and installation of lines and hoses of cooling of transmission
Removal and installation of an additional cooler
Removal and installation of automatic transmission
Replacement of the module of management with transmission (ТСМ) (only for АW-4 and 42RЕ)
Diagnostics of system of electronic control by automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions
|
Check of a condition and replacement of a support of transmission
|
Поддомкратьте the car also establish it on props.
Under the car insert the big screw-driver or mount into space between lengthening картера transmissions and a cross-section beam (models 2WD), or a distributing box and a cross-section beam (all-wheel drive models). Try to hook transmission or a distributing box slightly. Transmission should not rise a little considerably over a support pillow
|
For check of a condition of a support of transmission insert mount or the big screw-driver between lengthening картера and a cross-section beam (models 2WD) or between a distributing box and a cross-section beam (models 4WD) and try to raise this lever transmission over its support.
|
For replacement of a pillow of a support give bolts of its fastening to a cross-section beam and to transmission.
|
Components of typical assemblage of a support of transmission.
|
Slightly raise transmission or a distributing box a jack and take a support pillow. Pay attention that in a cross-section beam the apertures intended for centering of a support at its installation are provided.
Installation make upside-down. Track reliability of a tightening of fixture.
|
|
|
|