Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
- Automatic transmission
   The general information
   Diagnostics of malfunctions - the general information
   Removal and installation of the lever of switching
   Check of a condition and adjustment of a cable of switching
   The description, replacement and adjustment of a cable of a drive throttle заслонки in a mode kik-daun (TV-cable)
   Serviceability check, adjustment and replacement of the gauge-switch of the permission of start
   Adjustment of a cable lay блокиратора
   Check of a condition and replacement of a support of transmission
   Epiploon replacement
   The design description, removal and installation of lines and hoses of cooling of transmission
   Removal and installation of an additional cooler
   Removal and installation of automatic transmission
   Replacement of the module of management with transmission (ТСМ) (only for АW-4 and 42RЕ)
   Diagnostics of system of electronic control by automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions


e65f60b7

Adjustment of a cable lay блокиратора

 PERFORMANCE ORDER

    Translate the switching lever in position Р, and the ignition key - in position LOCK (Blocking). Give screws of fastening of facing of the lever of switching and the console (the Head the Body). For cable clearing delay the clamp button.
    For cable liberation delay the clamp button.
    Delay a cable forward, then release it and squeeze out the button of a clamp down to click.
    Delay a cable forward, then release it and squeeze out the button of a clamp down to click.
    For adjustment check do following procedures:
      Translate the switching lever in position Р. Check up functioning of the button of clearing of a clamp in the handle of the lever and the cylinder of the lock of ignition. The button should be in free position (wrung out), and the cylinder of the lock of ignition freely to rotate between positions OFF and LOCK. Translate the switching lever in position DRIVE (Movement) or REVERSE (Reverse gear) and again make sure of correctness of functioning of the cylinder of the lock of ignition. This time the cylinder should not rotate. Check up functioning of the lever of switching. Its conclusion from position Р should be possible only when the cylinder of the lock of ignition will turn in position OFF (Выкл), RUN (Movement) or START (Start). At a finding of the cylinder of the lock in positions ACCESSORY (Parking) or LOCK (Blocking).