Jeep Grand Cherokee

1993-1999 of release

Repair and car operation


Jeep Grand Cherokee
+ Cars of mark Jeep Grand Cherokee
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
- Automatic transmission
   The general information
   Diagnostics of malfunctions - the general information
   Removal and installation of the lever of switching
   Check of a condition and adjustment of a cable of switching
   The description, replacement and adjustment of a cable of a drive throttle заслонки in a mode kik-daun (TV-cable)
   Serviceability check, adjustment and replacement of the gauge-switch of the permission of start
   Adjustment of a cable lay блокиратора
   Check of a condition and replacement of a support of transmission
   Epiploon replacement
   The design description, removal and installation of lines and hoses of cooling of transmission
   Removal and installation of an additional cooler
   Removal and installation of automatic transmission
   Replacement of the module of management with transmission (ТСМ) (only for АW-4 and 42RЕ)
   Diagnostics of system of electronic control by automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions

e65f60b7

Check of a condition and adjustment of a cable of switching

Check

Cock against the stop a lay brake and make attempts of short inclusions of a starter at all positions of the lever of switching. Starter inclusion should take place only in positions of lever "" and N. If the starter is started at any of other positions of the lever, make draught adjustment (see more low). If after adjustment the starter on the former joins at distinct from Р or N transmission positions, it is necessary to make adjustment of the gauge-switch of the permission of start or to replace it (Section serviceability Check, adjustment and replacement of the gauge-switch of the permission of start).

Adjustment

 PERFORMANCE ORDER

    Establish the switching lever in position Р. Поддомкратьте the car also establish it on props. For clearing of a cable of switching separate a casing of a cable from an arm, then, for cable liberation release its adjusting clip.
    The switching cable is connected to the lever of switching by means стыковочного a socket of shariko-nested type; for рассоединения a socket simply knock over a tip of a cable from a small pin on the lever by means of a screw-driver.
    For a detachment of a cable from an arm flat-nose pliers compress together lock uvulas of a casing, then delay a cable with a casing from an arm.
    Make sure that the switching lever on transmission is taken away against the stop back on last clamp. Thus transmission will be in position Р. Make sure that lay блокиратор works, for what make attempt повращать карданный a shaft. At normal functioning блокиратора the shaft cannot be turned. Latch a casing of a cable of switching in an arm, then press down to click an adjusting clip, having fixed thereby a cable. Lower the car on the earth. At reliably cocked lay brake make sure that starter inclusion probably only of transmission positions Р and N. If draught is adjusted normally, however the starter is started in positions distinct from Р and N, check up serviceability of the gauge-switch of the permission of start (Section serviceability Check, adjustment and replacement of the gauge-switch of the permission of start). Check up smoothness of functioning of the lock of blocking of a steering wheel.