Jeep Grand Cherokee

1993-1999 of release

Repair and car operation

Jeep Grand Cherokee
- Cars of mark Jeep Grand Cherokee
   + Identification numbers of the car
   Acquisition of spare parts
   - Technics of service, the tool and the workplace equipment
      Technics of service
      Fixture
      The sizes of fixture
      Procedure and order of a tightening of carving connections
      Dismantling of components
      Prokladochnye surfaces
      Councils about removal of hoses
      The tool
      The workplace equipment
   + Поддомкрачивание and towage
   Start of the engine from the auxiliary power supply
   + Automobile химикалии, oils and greasings
   + Diagnostics of malfunctions
+ Options and routine maintenance
+ Рядный the six-cylinder engine
+ Engine V8
+ Procedure of the general and engine major repairs
+ Systems of cooling, heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ System of an electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of a gear change
+ Automatic transmission
+ Distributing box
+ Coupling and трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of an onboard electric equipment
+ Controls and operation receptions

Councils about removal of hoses

If your car is equipped by air central air, at all do not disconnect from conditioner components any hoses until the system will not be discharged in representation branch of the company or the expert in central airs of air of a workshop of car-care centre.

Measures of precautions which should be observed at removal of hoses are very close to that at removal of linings. Avoid damage of surfaces of unions and branch pipes on which hoses as it can be at the bottom of occurrence of leaks put on. In a special measure it concerns procedure of removal of hoses of a radiator. Owing to various chemical reactions occurs "прикипание" rubbers of hoses to interfaced surfaces of unions and branch pipes. For hose removal first of all ослабьте a collar of its fastening on the union. Then nippers with the sliding hinge seize a hose near to a collar and start to rotate it on the union / a connecting branch pipe to the right-to the left. Continue this procedure to a hose outright release, then remove a hose from the union. The small amount of silicone or other greasing will facilitate procedure if it can be entered into a backlash between the union and a hose. For simplification of procedure of installation of a hose grease an internal surface of a hose and an external surface of the union.

As extreme means, or in case of unequivocal necessity of replacement of a hose on the new end of a hose put on the union for removal can be knifed and then is separated from an union surface. Thus try not to damage a knife metal of the union/under of a connecting branch pipe.

In case of damage of a collar of fastening of a hose replace it with the new. Collars of braided type usually weaken eventually, therefore, without dependence from their condition, as required it is better to replace them with collars of screw type.